Installing H.323 on Trixbox 2.4
Submitted by joshelson on Fri, 01/04/2008 - 10:20am.
Has anyone had any experience or luck installing H.323 on Trixbox 2.4?
This forum has information on doing it on the 2.2 release, which basically just involves copying the ooh323.conf out of the /etc/asteriskXXX_samples directory.
This doesn't appear to be the same in 2.4.
Any success stories or hints for doing this? What's the consensus on Trixbox support for H.323 going forward?
Thanks,
Josh
RE: I have the same
Wed, 01/09/2008 - 10:04am
I should have updated the thread for the benefit of all.
I was able to get the H.323 driver (ooh323) installed by using the following procedure:
1. Download Asterisk-Addons-1.4.5 from Digium's website.
2. Extract files.
3. You will find a subdirectory in the extraction called "asterisk-ooh323c". CD to this directory.
4. Run the following commands.
./configure
make
make samples
NOTE: you will need to install the GCC, kernel-devel, and a few other packages, if I remember correctly.
5. Start / restart Asterisk.
6. Run a 'show channeltypes' to check H.323 registration.
Hope this helps!
Josh
http://www.trixbox.org/forums
Wed, 02/13/2008 - 6:28pm
Member Since:
2006-12-07