Home » Forums » trixbox forums » H.323

need a help on h.323

amir-ahrabi
Posts: 8
 Member Since:
2007-11-16
Submitted by amir-ahrabi on Wed, 02/20/2008 - 4:01pm.

hi
i configured ooh323, but when i try to dial my asterisk az a incoming call by dialing my asterisk server's ip i get it's caller id and then it says goodbye and then hangs up !!!! why ?can eney one help me!!?

‹ qeustion Has Anyone succeeded to install asterisk-oh323 module on Trixbox v2.2.3 ›


robmac
Posts: 5
 Member Since:
2007-12-20
See
Wed, 02/20/2008 - 6:58pm

See http://www.trixbox.org/forums/trixbox-forums/h-323/h323-mgcp-skin...



amir-ahrabi
Posts: 8
 Member Since:
2007-11-16
not my answer
Thu, 02/21/2008 - 2:02am

tnx but i couldn't find my answer! first of all a tried to call with every codec such az gsm , ulaw , alaw , g723 and g729 result is az same az past ! just hereing goodbye !!!!! why ? why didn't my trixbox server can't get it as a incoming call !!!!!! where i did wrong?



robmac
Posts: 5
 Member Since:
2007-12-20
If you install the new file
Thu, 02/21/2008 - 5:20am

If you install the new file and follow the documentation for configuring the endpoint then it should then work. The parameters for OOH323 can take a lot of work before you find out the correct settings - hence why I made the patch and wrote the endpoint configuration guidelines.
OOH323 currently only supports Ulaw & GSM but you need to make sure DTMF and all the other applicable settings match



Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.