support

Interface only shows Apache Test Page

thillis
Posts: 3
Member Since:
2007-10-24

I'll start off with the disclaimer. I’m very new to Trixbox and Linux. I installed the server and registered with no problems. I can access the interface through http://cp.trixbox.com I can not access the server through a browser and it's IP address. The IP address is private. Does that matter? I get a Test Page for Apache. It says "Seeing this instead of the website you expected?" The server is behind a 3060 Sonicwall with Enhanced OS. Very little has been done on the firewall to allow access. I was able to register the server and it does have access to the internet.

Is this interface where I set up my SIP trunk? I looked through the interface on cp.trixbox.com and only found limited configuration for SIP trunks there.

Thank you for any help.



kerryg
Posts: 6401
Member Since:
2006-05-31
There is no user interface

There is no user interface on the box itself. To configure a SIP trunk go to Options, VOIP, all the settings you may need are there.

--

Kerry Garrison
trixbox Community Director
VoipSpeak.net - Asterisk Tutorials



thillis
Posts: 3
Member Since:
2007-10-24
Documentation

All the "How to's" and other documentation that I have seen shows screen shots that look different then what I see. From what I can tell they are refering to the same version that I am using 1.0.3.13

Thanks for the help.



thillis
Posts: 3
Member Since:
2007-10-24
Documentation

All the "How to's" and other documentation that I have seen shows screen shots that look different then what I see. From what I can tell they are refering to the same version that I am using 1.0.3.13

Thanks for the help.



kerryg
Posts: 6401
Member Since:
2006-05-31
If you are using Pro you

If you are using Pro you ONLY log into http://cp.trixbox.com, if you are using trixbox CE, then you log onto the IP of the box.

--

Kerry Garrison
trixbox Community Director
VoipSpeak.net - Asterisk Tutorials



Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.