Installation Digium TE120P
Submitted by quocviet on Thu, 02/21/2008 - 11:59am.
Dear Experts,
I have installed the TE120P on the Trixbox 2.2.
As guide, I have dowloaded and Installed the Zaptel-1.2.22, Libpri-1.2.7 and Asterisk-1.2.26. But the system did not recognize this Card.
When openning system information menu, I saw that :
PCI Devices - Class 0080: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI]
- Ethernet controller: Digium, Inc.: Unknown device 0120
Could you please guide me how to install it correctly?
Thank for your advice,
Quoc Viet
Manual configure the zaptel.conf file
Sat, 02/23/2008 - 8:53pm
Dear skytelnet,
Thank for you soon reply,
As you guide, I searched on the web then finding some information how to install and upgrade Trixbox.
Now, I saw on the system inforamtion as below:
PCI Devices - Class 0080: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI]
- Ethernet controller: Digium, Inc. Wildcard TE120P single-span T1/E1/J1 card
It's mean that the system recognize our card.
When using CLI>zap show staus, It indicated:
Description Alarms IRQ bpviol CRC4
Wildcard TE12xP Card 0 UNCONFIGUR 22 0 0
ZTDUMMY/1 1 UNCONFIGUR 0 0 0
But when checkibf the zaptel.conf, Its content is only this information:
# Autogenerated by /usr/local/sbin/genzaptelconf -- do not hand edit
# Zaptel Configuration File
#
# This file is parsed by the Zaptel Configurator, ztcfg
#
# It must be in the module loading order
# Span 1: ZTDUMMY/1 "ZTDUMMY/1 1"
# Global data
loadzone = us
defaultzone = us
Could you please tell me why it could not autogenerate for TE12xP card?
Thank for your advice,
Best regards,
Quoc Viet
Even after auto-generation
Mon, 02/25/2008 - 1:39pm
Even after auto-generation you still have to edit this file manually.
You will have to define your span in zaptel.conf such as below.
# Autogenerated by /usr/local/sbin/genzaptelconf -- do not hand edit
# Zaptel Configuration File
#
# This file is parsed by the Zaptel Configurator, ztcfg
#
# It must be in the module loading order
# Span 1: WCTE11XP/0 "TE110P Board 0"
span=1,1,0,esf,b8zs
fxsls=1-16
unused=17-24
# Global data
loadzone = us
defaultzone = us
You will also have to make a definition in zapata-auto.conf as well
; Autogenerated by /usr/local/sbin/genzaptelconf -- do not hand edit
; Zaptel Channels Configurations (zapata.conf)
;
; This is not intended to be a complete zapata.conf. Rather, it is intended
; to be #include-d by /etc/zapata.conf that will include the global settings
;
callerid=asreceived
; Span 1: WCTE11XP/0 "TE110P Board 0 Local T-1"
context=from-zaptel
signalling=fxs_ls
;Incoming and Outgoing Lines Local T-1
group=3
channel=1,3,5-14
Member Since:
2007-01-31