Home » Forums » trixbox forums » SIP and IAX trunks and providers

Outgoing call problem, incoming ok

michele_petrazzo
Posts: 1
 Member Since:
2008-03-21
Submitted by michele_petrazzo on Wed, 04/16/2008 - 1:13pm.

Hi all,
I have trixbox 2.6 for my tests with four extension, one outgoing route and one trunk. Internal calls (from - to extensions) works well.
The trunk are a voip provider (mclink). I configure it and now I can receive calls from "outside" (with regional number) and trixbox send and receive voice to and from my voip phone well.
When I try to use the "outgoing" side, the call starts, into the log I see "SIP/mclink-097b4b78 is ringing " and "SIP/mclink-097b4b78 is making progress passing it to SIP/22-097ac680"
(and I hear the cellular phone called ringing), but on the voip phone only a very little "toch" (about 1/10 sec) and nothing other... If I reply, no voice in or out.

With the same voip account configured into a linksys PAP2T, on the same network segment, all work well (incoming and outgoing)...

Where start to look?

Thanks,
Michele

‹ Looking for a good trunks provider (outgoing incoming and 1-800) Broadvoice Service - ›


bimal.chudasama
Posts: 2
 Member Since:
2007-08-27
Michele Are you using
Sat, 04/19/2008 - 6:49pm

Michele

Are you using separate trunk for each leg ( outbound and inbound) or just one for both? If just one check the outgoing call rules. Trixbox always has the business line setup to dial 9 for outside. try 9xxxxxxxxx and see if it works.



Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.