X100P Red Alarm in the zztool
Submitted by chastx on Wed, 05/23/2007 - 12:22pm.
For those trying to clear a Red Alarm in the zztool display on a newly installed X100P - It took me a few days to figure out that the Red Alert status on our card would clear after we plugged in the dial tone from the phone jack - once that was done, the Alarm cleared and the card was usable.
I thought this might help someone....
Helped Fix my Box
Thu, 05/01/2008 - 3:49pm
Thanks chastx,
I was having Red Alarm issues and couldn't get a new Box i made this week with all the current software.
First indication of problem came as an Error in Loading Zap in Asterisk,
chan_zap.so, Could not load the channel,
So i went into figuring out if there was anything wrong with my zapata.conf file, all seemed good.
Went out to my zaptel.conf file, it all seemed good, but
Channel 01: FXS Kewlstart (Default) (Slaves: 01)
1 channels to configure.
Tought it should say 1 Channel configured, then i found out it was just a version change.
Finally found the Red Alarm, and read your post, fixing the box was as easy as plugging in the Line.
Thanks man.
Ricrc
Member Since:
2006-11-10