Thanks for supporting Grandstream Moderated Forum
Submitted by gstreammkt on Mon, 01/29/2007 - 8:48pm.
Hi Everyone -
Just a quick note to say thank you for your response to our forum. Grandstream welcomes your comments and feedback. Our engineers and support team find most discussion topics helpful. We will be as responsive as possible to your questions and concerns, but should we not respond immediately, please check back next day.
Please keep in mind that Grandstream has a support network in place, and it was not intended for the Grandstream moderated forum to replace our established support network. We actively support the trixbox community and want to facilitate your exchange of ideas and solutions, particularly as they pertain to the trixbox /asterisk community.
Thanks for your continued support and use of our products. We hope this forum will provide the extra support you need. Keep on discussing!
Grandstream
Re: Thanks for supporting Grandstream Moderated Forum
Tue, 11/21/2006 - 11:24am
Thanks to everyone for the effort that will be useful to integrate TB and GS products.
Just a note on your low response time for questions like this
http://www.trixbox.org/modules/newbb/viewtopic.php?topic_id=6531&...
I really appreciate a solution for this because everything else is fine and I'm very satisfied.
Re: Thanks for supporting Grandstream Moderated Forum
Wed, 01/10/2007 - 3:04am
Hi Grandsteam
I have a Grandsteam BT-100 IP Phone behind the NAT that IP Phone register to the real IP Trixbox 2.0 rc1 free pbx .
The freepbx's extention configuration is nat = yes and qualify = yes that result is unrechable that phone can call out but call in .
I try qualify = 50 result is lagged (64ms) that phone can call out but can't call in yet.
Would you help me to sovle this problem? Thanks,
Best Regards,
David Sun
Setting PSTN Impedance
Wed, 03/05/2008 - 5:07pm
i recently bought two (2) HT-503 adaptors. my problem is - which country should i select to set the FXS/FXO port to 900-ohms? not just only 900-ohms but i'm asking for a country <-> impedance lookup table.
i asked Grandstream Tech Support for the settings but they advised me to search the Call Progress Tone database! my goodness .... i sent 2 more follow-up emails to no avail.
if anyone in this forum who knows this information, please help me because the echo problem is very serious.
HT503 - PSTN Call Waiting?
Fri, 04/18/2008 - 6:40pm
Does the HT503 support PSTN call waiting (and call waiting ID) on an active PSTN call?
That is, when the FXS (or VoIP port) is ALREADY on a PSTN call, and the FXO line is subscribed to call waiting (with ID) from telco, you hear the beep. Can the FXS port (or VoIP side) hook-flash the FXO line to answer the waiting call? (Can it also receive the PSTN call waiting ID?)
I have similar product which can't accomplish the above. If the 503 can, consider it purchased.
*PS, this is not the same as call waiting on the FXS port (on a VoIP call), with the FXO line idle.
Thanks.
Member Since:
2006-11-07