Hudlite not showing outbound calling number when utilizing "w" for trunk dial prefix
Submitted by miamiman60 on Fri, 04/04/2008 - 5:40am.
Hello,
I've been trying to find information relating to my issue and have been unsuccessful. I have several MCI FXO trunks where I need to apply delay, in order to not chop off digits prior to dial tone. In order to apply the delay, I'm utilizing the wait "w" feature in the ZAP trunk configuration - under "Outbound Dial Prefix".
The issue is that when I utilize the "w" in the Outbound Dial Prefix, Hudlite shows the number as unknown for outbound calls. Under normal conditions without the "w", Hudlite will display the outbound called number.
Has anyone run into this issue? And, have you also found a solution that will show the outbound called number?
Thanks!
Additional Information
Thu, 04/10/2008 - 11:35am
I haven't seen any activity with my issue, so I've decided to add some additional information on my configuration:
1. Running Trixbox 2.2.12
2. Dell Poweredge T-105 Server (1GB Mem, 160GB HD, etc..)
3. Rhino R8FXX-EC PCI Card - with 4 dual FXO modules - Six ports in use, two unused
4. Six MCI Local PSTN lines connected to the Six FXO ports in use.
As I stated above, the issue is that when I utilize the "w" (Pausing for dial tone) in the Freepbx Trunk Outbound Dial Prefix field, Hudlite client shows the number as "unknown" for outbound calls. But, without the "w", Hudlite client will display the outbound called number.
Any assistance from anyone would be greatly appreciated.
Best regards,
Luis
Member Since:
2006-07-17