TAPI and MS Access
Submitted by atmezferix on Fri, 01/19/2007 - 10:42pm.
Hoping someone can help me with this one.I have a Microsoft Access database running and would like to dial a phone number from it.I was hoping I could do it with TAPI but can't find any documentation on calling up Hudlite to dial.Is there a command line switch that can be run to pass the number onto it ?I have found a function using the tapi library to dial a number from access but this launches the MS phone dialer and obviously tries to dial using a modem. Is there a way to get this to use Hud ?Any help would be appreciated.
Re: TAPI and MS Access
Thu, 01/18/2007 - 6:49am
Re: TAPI and MS Access
Thu, 01/18/2007 - 8:01am
Managed to do it using Hud.
I downloaded ActivaTSP and started to configure it but could seem to find much documentation on it.
Whilst in the Phone dialer i noticed that HUDTAPI is in there as an option.
I set it as the default phone dialing option and its all working now.
Thanks for you help... Got there in the end.
Re: TAPI and MS Access
Fri, 01/19/2007 - 10:42pm
I can't seem to get it to work. I installed the Windows Dailer (TAPI) but when I click start call in Outlook I get a the following error after a small wait.
Unable to complete an operation requested by the automatic phone dialer. Please make sure your modem, phone, and phone line are properly configured.
I checked under Dialing Options and it is set to HUDTAPI. Any suggestions? There doesn't seem to be much documentation on this.
Member Since:
2006-06-02