Home » Forums » Vendor Moderated Forums » Rhino Equipment

Rhino don't show caller ID

Weerasaky
Posts: 6
 Member Since:
2007-06-26
Submitted by Weerasaky on Mon, 05/05/2008 - 6:56am.

When i have incoming call to rhino zap trunk it don't show caller ID but I connect

I use Digium T1/E1 card (4Port) to install DID by E1 and 2 rhino 24CB when we have incoming call from DID it show caller ID from Telecom company but when incoming call to rhino it don't show caller ID. Does rhino cb support caller ID.

‹ Videos..... RCBFX8 - 0 channels detected ›


jfinstrom
Posts: 891
 Member Since:
2007-03-07
I apologize I need more
Mon, 05/05/2008 - 8:38am

I apologize I need more details to give an accurate answer. Wht type of channel banks are these.
What is your topology.
device a goes to device goes to device... please explain the path of the call from end to end...

Thanks,

--

James
Community Manager
Rhino Equipment
All Products U.S. Made and Supported



Weerasaky
Posts: 6
 Member Since:
2007-06-26
Rhino caller ID
Mon, 05/05/2008 - 5:04pm

Dear Jame

thank your for support.

I have rhino 24 Port FXO connect to T1/E1 Card On port 1 of card I install DID at port 2-3 I install Rhino FXO 24 Port I confuse about caller ID why when receive incoming call to DID port it show callerID at my extension but on Rhino i connect rhino zap trunk with telecom company and Mobile gsm interface to trunk when we have incoming call it don't show caller ID. I use trixbox 2.2.5



jfinstrom
Posts: 891
 Member Since:
2007-03-07
are you set to LOOP and KEWL
Mon, 05/05/2008 - 8:05pm

are you set to LOOP and KEWL

--

James
Community Manager
Rhino Equipment
All Products U.S. Made and Supported



Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.