Home » Forums » Vendor Forums - Certified » Sangoma

RPM's for 2.4.0 RC4

rwjblue
Posts: 13
 Member Since:
2007-04-13
Submitted by rwjblue on Fri, 12/28/2007 - 7:46am.

Does the 2.4 RC4 contain the required wanpipe RPM's for setting up an A102D? I have seen a few posts on the forums that 2.3.0.5 was the last supported version since the CentOS kernel was changed while moving to CentOS 5.1. (I know that I can install from source, but it is much easier with the RPM's)

I am anxiously awaiting the 2.4 release and was just curious how this was progressing...

Thanks,

Robert Jackson

‹ A400 card problem ??? Issues - Configuration problems/questions ›


kerryg
Posts: 6665
 Member Since:
2006-05-31
The Wanpipe utils are
Fri, 12/28/2007 - 8:57am

The Wanpipe utils are current as of 2.3.0.11 so they will work fine now.

--

Kerry Garrison
http://www.VoipStore.com - http://www.888VoipStore.com
Facebook: http://facebook.com/VoipStore
(888) VOIPSTORE - (888) 864-7786



bdis
Posts: 111
 Member Since:
2007-01-04
I'm trying 2.4.0.rc4 with
Sat, 12/29/2007 - 5:56pm

I'm trying 2.4.0.rc4 with the yummed version of the wanpipe drivers and the card is detected (A200D) but I can't get any calls in or out of the system. Exact same setup on the 2.3.0.7 version works fine. Should I wait for updated drivers or has anyone else run into this issue and gotten it resolved?

It looks like the setup-sangoma script isn't updating zapata.conf or zapata-auto.conf



bdis
Posts: 111
 Member Since:
2007-01-04
Issue resolved itself I ran
Sat, 12/29/2007 - 6:30pm

Issue resolved itself
I ran a amportal stop, then wanrouter stop
Ran a wanrouter start, then a ztcfg -vvv to make sure all the ports were detected
Then ran amportal start and everything is working now.

I guess I zigged when I should have zagged?



bdis
Posts: 111
 Member Since:
2007-01-04
Actually the phones ring but
Sun, 12/30/2007 - 6:59pm

Actually the phones ring but I can answer but no audio is passed. BAck to the drawing board



CMCLAIN
Posts: 169
 Member Since:
2007-01-24
oslec issue
Sun, 12/30/2007 - 7:44pm

remove "echotraining=800" from zapta.conf and reboot... everything will be fine.
at least it was for me...



bdis
Posts: 111
 Member Since:
2007-01-04
echo training was already
Mon, 12/31/2007 - 1:11pm

echo training was already removed
It works for a while and then quits



CMCLAIN
Posts: 169
 Member Since:
2007-01-24
have you upgraded to 2.4 yet?
Mon, 12/31/2007 - 2:59pm

What version of trixbox do you have on your machine?



Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.