TDMV_HW_DTMF also for A200d ???
Submitted by tkmgmbh on Thu, 03/27/2008 - 7:56am.
trixbox 2.6.0.5 and A200d (rpm repo drivers)
we have still problems with dtmf recognition.
from one fax machine everytime we loose the second digit. e.g. when i call 0215112345 asterisk recognise 015112345...
when i call with a normal telephone everything is ok. (i cant change any timing or dtmf settings on the fax machine.)
is the new hw dtmf recognition feature in wanpipe 3.3.x also available for the sangoma A200d analog card or only for A10xd????
a recording with ztmonitor sounds normal.
is it possible that when you dial the first digit the echo canceler produce something like noise??
or what could be the problem?
thanks for any answer...
"d" model + wanpipe-3.3.x
Thu, 04/24/2008 - 3:58pm
Hello,
If you have d-model card you can enable hardware DTMF feature with wanpipe-3.3.x. Go to http://wiki.sangoma.com/wanpipe-asterisk-trixbox-rpms#BRI-HWDTMF and download RPMs according to your trixbox version . Run "setup-sangoma" to configure the analog card. It will ask you, if you like to enable hardware DTMF or not; select YES and you are set to go. We have customer running hardware DTMF in production with digital and analog cards.
Thank you,
thank you for your reply.
Fri, 04/25/2008 - 1:20am
Re: Model Number
Fri, 04/25/2008 - 3:00pm
You can run:
wanrouter hwprobe
or
wanrouter hwprobe verbose
This will show you the card model number, hwec capability, firmware version number ... etc..
http://wiki.sangoma.com/wanpipe-asterisk-operation
I ran the wanrouter commands
Sun, 04/27/2008 - 9:06am
And his is my output:
-------------------------------
| Wanpipe Hardware Probe Info |
-------------------------------
1 . AFT-A200-SH : SLOT=4 : BUS=4 : IRQ=11 : CPU=A : PORT=PRI : HWEC=32 : V=10
Card Cnt: S508=0 S514X=0 S518=0 A101-2=0 A104=0 A300=0 A200=1 A108=0
If I am reading this right, am I running an "A" model?
Charles
Re: Card Model
Sun, 04/27/2008 - 6:40pm
Well the above command shows you the following
-> card type: A200-SH -> analog 4 port card
-> HWEC: 32 -> this means card model D with echo cancellation
-> Firmware Version: 10. -> you are not running latest firmware
http://wiki.sangoma.com/wanpipe-linux-drivers#aft_firmware
As you can see the above command gives you everything you need to know about your card.
The "wanrouter hwprobe verbose" option would should you FXO/FXS ports.
I hope this answers your questions.
Nenad
Sangoma Technologies
Member Since:
2007-05-14