GXV-3000 Auto Dial / Off Hook Dial
I do see this on my
Thu, 04/03/2008 - 11:43am
I do see this on my GXP-2020s but not my GXV-3000. Below is my Phone Info for Versions and below that is my advanced page.
Hardware Revision: Main-- 3.1 Rev D Interface-- 3.1 Rev D
MAC Address: 00:0B:82:12:A8:DD
Product Model: GXV3000
Software Version: Application-- 1.0.1.27 Loader-- 1.0.0.9 Boot-- 1.0.1.1
Grandstream Device Configuration
STATUS BASIC SETTINGS ADVANCED SETTINGS ACCOUNT 1 ACCOUNT 2 ACCOUNT 3
Admin Password: (purposely not displayed for security protection)
G723 rate: 6.3kbps encoding rate 5.3kbps encoding rate
Silence Suppression: No Yes
Voice Frames per TX: (up to 10/20/32/64 for G711/G726/G723/other codecs respectively)
Video frame rate:
Video bit rate (kbps):
Video Packet Size: (from 300 to 1400, default is 1400)
Video Rate Control: Frame TMN8
Video Frame Skipping: No Yes
Sharpening Filter: (0-9, 0 means disabled, default is 5)
Brightening Filter: (0-9, 0 means disabled, default is 5)
Enable Video Surveillance: No Yes
Surveillance RTSP Port: (default is 554)
Streaming RTSP Server:
Streaming RTSP User ID:
Streaming RTSP Password: (purposely not displayed for security protection)
Layer 3 QoS: (Diff-Serv or Precedence value)
Layer 2 QoS: 802.1Q/VLAN Tag 802.1p priority value (0-7)
No Key Entry Timeout: (in seconds, default is 4 seconds)
Use # as Dial Key: No Yes
local RTP port: (1024-65535, default 5004)
Use random port: No Yes
keep-alive interval: (in seconds, default 20 seconds)
Use NAT IP (if specified, this will be used in SIP/SDP message)
STUN server: (URI or IP:port)
Firmware Upgrade and
Provisioning: Upgrade Via TFTP HTTP
Firmware Server Path:
Config Server Path:
Firmware File Prefix:
Firmware File Postfix:
Config File Prefix:
Config File Postfix:
Allow DHCP Option 66 to override server:
No Yes
Automatic Upgrade:
No Yes, check for upgrade every minutes (default 7 days)
Always Check for New Firmware
Check New Firmware only when F/W pre/suffix changes
Always Skip the Firmware Check
Authenticate Conf File:
No Yes (cfg file would be authenticated before acceptance if set to Yes)
Screen Saver Download: Enable Screen Saver Download:
No YES, HTTP YES, TFTP
Screen Saver Server Path:
Phonebook XML Download: Enable Phonebook XML Download:
No YES, HTTP YES, TFTP
Phonebook XML Server Path:
Remove Manually-edited entries on Download:
No Yes
Network Screen Saver: Enable Network Screen Saver:
No YES, HTTP
Network Screen Saver Path:
Weather Forecast: Enable Weather Forecast:
No YES, HTTP
Weather Forecast Server Path:
Headline News: Enable Headline News:
No YES, HTTP
Headline News RSS Server Path:
DTMF Payload Type:
Syslog Server:
Syslog Level:
NTP Server: (URI or IP address)
Allow DHCP Option 42 to override NTP server:
No Yes
Distinctive Ring Tone: Custom ring tone 1, used if incoming caller ID is
Custom ring tone 2, used if incoming caller ID is
Custom ring tone 3, used if incoming caller ID is
System Ring Tone:
Call Progress Tones:
Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
Busy Tone
Reorder Tone
Start Browser On Boot: No Yes
Enable Browser Toolbar: No Yes
Browser Home Page: (default is about:/start.htm)
Disable Call-Waiting: No Yes
Disable Call-Waiting Tone: No Yes
Disable Direct IP Call: No Yes
Use Quick IP-call mode: No Yes
Allow Media Loopback: No Yes
Lock keypad update: No Yes (configuration update via keypad is disabled if set to Yes)
Any idea on a estimated time
Sat, 04/12/2008 - 8:56am
Any idea on a estimated time frame or the possibility for beta firmware that has it I can test ... I am developing an appliance that needs this for it to work and I have a deadline and Grandstream's documentation stated the phone supported ... I appreciate your help with this matter!
Member Since:
2007-12-03